Quintum Technologies Tenor Call Relay SP - Manual (Page 63)

6-6 P/N 480-0048-00-10
Chapter 6: Working with SNMP
EDESC
• The quintum.exe file is added to the HPOVRoot\bin directory.
• These files are added to the HPOVRoot\bitmaps\C directory:
Tenor_chassis.ico
Tenor_A.ico
Tenor_D.ico
• The quintum.fields file is added to the HPOVRoot\fields\C directory, and is installed and verified using
the "OVW -fields" command.
• The quintum.reg file is added to the HPOVRoot\registration\C directory.
• These files are added to the D:\hpovnnm\symbols\C\Connector directory:
CONNECTOR_QDVOIP
CONNECTOR_QAVOIP
CONNECTOR_QCVOIP
7. HP Openview will then identify and “auto-discover” the Tenor unit as an SNMP agent. An icon will
appear on the screen to represent each Call Relay SP unit. See below.
Figure 6-1 Tenor SNMP Agent Icon
Configure network manager IP address
Through Call Relay SP’s Command Line interface (CLI), you can configure the IP address for the network
management site where HP Openview is running. Once the IP address is configured, the Call Relay SP will be
able to process and generate traps for existing alarms, which will enable HP Openview to monitor the Call
Relay SP unit for alarm states.
To set the IP address, use the following CLI command:
con-MasterChassis> snmptrapip1 . This command configures the IP address of the network manage-
ment site in the Call Relay SP unit from which the SNMP traps will be generated. Valid entry: The index num-
ber of 1-3 (the index number is used to designate the index # for the network manager to be used) followed by
the IP address for the network management site.You can assign a Call Relay SP unit up to three network man-
agers; each manager will have a different index number.
Assign an IP address as follows:
NOTE: The following instructions assume your PC is running Windows 95 or later.
1. Click on Start> Run. The Run window will appear.