Quintum Technologies Tenor Call Relay SP - Manual (Page 29)

P/N 480-0048-00-10 2-11
Chapter 2: Hardware Components
Cables
The cables listed in Table 2-5 are required to connect a Call Relay SP to various interfaces. Contact Quintum
for ordering information, if necessary.
Table 2-5 Cables Supported
RJ-45 Ethernet Cable (10/100)
An RJ-45 (10/100 Base-T) straight through cable is used to connect Call Relay SP to an Ethernet LAN. Cable
pinouts are listed in Table 2-6. Color specifications are applicable to the RJ-45 cable provided.
Figure 2-9 RJ-45 (10/100 Base-T) Connector Pinouts
Table 2-6 RJ-45 (10/100 Base-T) Connector Pinouts
Cable Usage
RJ-45 Ethernet cable (grey) Connection to Ethernet LAN 10/100.
DB-9 Serial RS-232 (for use with CPU) Connection to PC’s asynchronous console
port.
Detachable (IEC) AC Power Supply Cord (for AC
units only) Connection to AC power jack.
Pin # Signal Definition Color
1 TX + Transmit Data White w/orange
2 TX - Transmit Data Orange
3 RX + Receive Data White w/green
4 Unused Unused Blue
5 Unused Unused White w/blue
6 RX - Receive Data Green
7 Unused Unused White w/Brown
8 Unused Unused Brown
Pin # Connects to Pin #
1
2
3
4
5
6
7
8 1
2
3
4
5
6
7
8