Quintum Technologies Tenor Call Relay SP - Manual (Page 35)

P/N 480-0048-00-10 3-5
Chapter 3: Installation
Connect to PC Console
You will need to connect the Call Relay SP unit to your PC’s serial port via RS-232 connection. (This connec-
tion will be used when you assign an IP address to the unit. For the instructions below, it is assumed you are
connecting to a PC.)
NOTE: For illustration purposes, the AC unit is shown.
Figure 3-3 Connect to PC Com
NOTE: You must use a DB-9 Serial RS-232 cable with a DB-9 male connector (see section Chapter 2:
Hardware Components for pinouts) to connect the unit to a PC.
1. Insert the male end of the DB-9 cable (grey cable if provided by Quintum) into the CPU card’s rear port
labeled Console. (See Chapter 2: Hardware Components for serial RS-232 connector pinouts.)
2. Insert the female end of the DB-9 cable into your PC’s serial port (see your PC documentation for more
information about this port).
DB-9
CP
U
2
4
8
3
7
26 15
TX
/R
X 1 2 3 4
Li nk Co
n
fig
1 2 3 4
Of
f
On
C
o nsole
10/1
0
0
Et
h
e rn
e t
1
0
Unit Rear (AC view)