Hall Research VSA-51-R - Manual (Page 19)

Digital AV Room Control System
17
WARNING
• The ceiling structure must be capable of supporting at least 5 times the weight of the projector and the CEILING
PLATE kit. Incorrect installation can cause the projector to fall and cause injury.
• Always install so that the load is carried by the ceiling support structure through the guide wires and quick locks
supplied.
• Use the specified bolts and screws in the specified places and tighten them firmly. Failure to do this could cause
injury if the projector falls.
CAUTION
• Do not attempt to perform this work by yourself.
• Manufacturer assumes absolutely no responsibility for injuries and damages that may occur due to improper
installation and handling.
• Avoid installing in locations where the temperature and humidity are excessively high, and where contact with any
water is possible. These can result in fire or electric shock.
• Do not install close to an air conditioner intake or outlet. Do not install in locations where there are excessive
amounts of dust, oily smoke or tobacco smoke. Fire could result.
• Do not block the ventilation holes. Leave sufficient clearance in regard to the surroundings to avoid blocking the
ventilation. The internal temperature could elevate and possibly result in fire.
• Do not install in locations where there is excessive vibration or impact. Injury and damage could result from the
projector mount falling.
2.7.1.2 Installation