beautypg.com

Maintenance, 16 access user interface and main pcb, 17 main pcb – Glow-worm Ultracom hxi User Manual

Page 42: 18 user interface, 19 fuse, main pcb - control box, 21 inner casing panel seal

background image

0020107233_00 - 06/11 - Glow-worm

MAINTENANCE

- 42 -

13.16 access User Interface and Main PCb

For access, refer to section 13.1.

Remove control box retaining screw, see diagram 13.11.

Hinge down the control box.

Release the control box cover by carefully pressing the four

retaining latches, see diagram 13.11.

13.17 Main PCb

IMPoRTanT: When replacing the board refer to instructions

supplied with the replacement.

For access, refer to section 13.16.

Remove the electrical connections to the PCB.

Ease back the four PCB retaining clips and withdraw the PCB

from the retaining lugs, see diagram 13.12.

When refitting the rear panel ensure the leads are not

trapped.

When replacing the board refer to instructions supplied with

the replacement.

13.18 User Interface

IMPoRTanT: When replacing the board refer to instructions

supplied with the replacement.

Refer to section 13.16 for access.

Remove main PCB, refer to section 13.17.

Remove electrical connection.

Gently ease back the retaining clips, see diagram 13.13.

Withdraw the board.

13.19 fuse, Main PCb - Control box

For access, refer to section 13.16.
The fuse is located at top left hand side of the PCB, see

diagram 13.12.

13.20 Control box

For access, refer to section 13.16.

Remove relevant plugs and connectors, refer to wiring

diagram 12.4.

Withdraw grommets and leads so they are hanging loose.

Unthread the retaining cord and remove the control box by

drawing it outwards away from its retaining slots, see diagram

13.11.

13.21 Inner Casing Panel Seal

For access, refer to section 13.1.

Refer to diagram 11.8.

Remove the inner casing panel.

To replace remove the old seal, thoroughly clean the casing

surfaces. Fit the new seal, it is supplied to the correct length.

Refit the inner casing panel.

noTe: Ensure the seal is fitted correctly giving an airtight

joint.

Diagram 13.12

Diagram 13.13

13355

13692

Diagram 13.11

CHASSIS FRONT

CONTROL BOX

SERVICE

POSITION

RETAINING

LATCHES (4)

RETAINING

SCREW

CONTROL BOX

COVER

RETAINING

CORD

13523

RETAINING

CLIPS (4 OFF)

FUSE

MAIN PCB

RETAINING

LUGS

230V