Nortel Networks 8000 User Manual
Page 312
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
8 Frame relay configuration
Nortel Secure Router 8000 Series
Configuration -WAN Access
Run the
interface
interface-type interface-number command to enter the FR interface
view.
Run the
interface mfr
interface-number command to enter the MFR interface view.
Step 3
Run:
fr Imi type { ansi | nonstandard | q933a }
The FR LMI type is configured.
Step 4
Run:
timer hold seconds
The command configures the polling interval (determined by T391) on the DCE device.
Step 5
Run:
fr Imi n391dte n391-value
The command configures the LMI N391 parameters on the DTE device.
Step 6
Run:
fr Imi n392dte n392-value
The command configures the DTE N392 parameter.
Step 7
Run:
fr Imi n393dte n393-value
The command configures the DTE N393 parameter.
—End
8.5.3 Configuring frame relay LMI and related parameters of DCE
Do as follows on the routers:
Step 1
Run:
system-view
The system view appears.
Step 2
Choose one of the following steps to enter the corresponding interface view as required.
•
Run the
interface
interface-type interface-number command to enter the FR interface
view.
•
Run the
interface mfr
interface-number command to enter the MFR interface view.
Step 3
Run:
fr Imi type { ansi | nonstandard | q933a }
The command configures the FR LMI type.
Step 4
Run:
fr Imi t392dce t392-value
8-22
Nortel Networks Inc.
Issue 5.3 (30 March 2009)