Enabling iphc compression on the interface, Enabling vj tcp compression on the interface – Nortel Networks 8000 User Manual

Page 147

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Nortel Secure Router 8000 Series

Configuration -WAN Access

6 PPP and MP configuration

OQ NOTE

After you configure the packet compression or header compression, the configuration takes effect only

after the

restart

command, or the

shutdown

and the

undo shutdown

commands are used. If you apply

the compression to MP, you must use the

restart

command, or the

shutdown

and the

undo shutdown

commands on all the interfaces bound by MP.

—End

Enabling IPHC compression on the interface

Do as follows on the routers:

Step 1 Run:

system-view

The system view appears.

Step 2 Run:

interface interface-type interface-number

The interface view appears.

Step 3 Run:

ppp compression iphc

The command enables IPHC on the interface.

Step 4 (Optional) Run:

ppp compression iphc [ nonstandard | rtp-connections rtp-connections | tcp-connections

tcp-connections ]

The command configures the parameters related to IPHC.

Step 5 Run:

restart

The command restarts the interface.

CQ NOTE

After you configure the packet compression or header compression, the configuration takes effect only

after the

restart

command, or the

shutdown

and the

undo shutdown

commands are used. If you apply

the compression to MP, you must use the

restart

command, or the

shutdown

and the

undo shutdown

commands on all the interfaces bound by MP.

—End

For the details about the IPHC, refer to the

Nortel Secure Router 8000 Series Configuration

Guide - QoS.

Enabling VJ TCP Compression on the Interface

Do as follows on the routers:

Step 1 Run:

system-view

Issue 5.3 (30 March 2009)

Nortel Networks Inc.

6-21