Preconfiguration tasks, Data preparation, Configuration procedures – Nortel Networks 8000 User Manual
Page 136
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
6 PPP and MP configuration
Nortel Secure Router 8000 Series
Configuration -WAN Access
This section describes how to configure PAP unidirectional authentication.
Preconfiguration tasks
Before configuring PAP authentication, complete the following tasks:
•
Configuring physical attributes of the router interfaces.
•
Encapsulating the interface with PPP.
Data preparation
To configure PAP, you need the following data.
No.
Data
1
Interface number of the router
2
Username and password of the peer to be authenticated
Configuration procedures
No.
Procedure
1
Configuring a local router to authenticate ilts peer in PAP mode
2
Configuring the peer to be authenticated by the local router in PAP mode
3
6.3.2 Configuring a local router to authenticate iIts peer in PAP
mode
Do as follows on the routers:
Step 1
Run:
system-view
The system view appears.
Step 2
Run:
aaa
The AAA view appears.
Step 3
Run:
local-user user-name password { simple | cipher } password
The command adds the user name and password of the authenticated into the local user list.
Step 4
Run:
quit
6-10
Nortel Networks Inc.
Issue 5.3 (30 March 2009)