Nortel Networks 8000 User Manual
Page 239
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
7 LAPB and X.25 configuration
Nortel Secure Router 8000 Series
Configuration -WAN Access
x25 switch svc x.121-address [ sub-dest destination-address ]
[ sub-source
source-a^^ress ] xot ip-a^^ress1 [ ip-address2 ]
[ ip-address6 ] [ xot-option ]
The command configures an SVC XOT route.
CQ NOTE
You must configure the local X.25 route in the SVC mode.
—End
PVC
Do as follows on the routers:
Step 1
Run:
system-view
The system view appears.
Step 2
Run:
interface serial interface-number
The interface view appears.
Step 3
Run:
x25 xot pv^c pvc-number1 ip-ad^d^ress interface serial interface-number pvc pvc-number2
[ xot-option ]
The command configures the PVC XOT route.
—End
7.6.5 Configuring optional keepalive and Xot-source attributes
SVC
Do as follows on the routers:
Step 1
Run:
system-view
The system view appears.
Step 2
Run:
x25 switch svc x.121-address [ sub-dest destination-address
source-address ] xot ip-address
[ [ timer seconds ]
serial interface-number ]
] *
The command configures SVC Keepalive and XOT-source attributes.
—End
[ sub-source
retry times ] [ source
7-36
Nortel Networks Inc.
Issue 5.3 (30 March 2009)