Connecting a monitor, Connecting the power cable, U.s.a. model – Yamaha CDR-HD1500 User Manual
Page 17: Europe, u.k. and australia models, Preparing the remote control, Installing batteries, Close the cover until it snaps into place, Battery replacement, Notes on batteries, Remote control operation range
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
CONNECTIONS
Connecting a monitor
You can display ihe list of groups or tracks to be playeck copying/recording settings or the list of setting items on the monitor by connecting
the monitor to this unit. Connect the S VIDEO jack or the VIDEO jack whichever available on your monitor.
Connecting the power cable
[U.S.A. model]
Plug the power cable into the AC inlet when all connections are complete, and then plug in the power cable to the wall outlet.
[Europe, U.K. and Australia models]
Plug in this unit to the wall outlet when all connections are complete.
£T>
m
О
СЛ
5
m
о
PREPARING THE REMOTE CONTROL
■ Installing batteries
1
m
Press the hook
(
a
)
of the battery cover to remove it.
2.
Insert 2 batteries (AA, UM-3 or R6 type) according to
the polarity markings on the inside of the battery
compartment.
3.
Close the cover until it snaps into place.
Battery replacement
!f you find lhal the remote control must be used closer to this unit
than usual, the batteries are weak. Replace both batteries with new
ones.
Notes on batteries
Use only AA, UM-3, or R6 type batteries for replacement.
Do not mix a new battery w'ilh a used one.
A rechargeable battery cannot be used.
Do not mix different types of battery.
Do not attempt to short out the hatteries hy directly comieetitig the
pitis (+) atid the tnitius (-) with a piece of nielal.
Remove the batteries if the remote control will nol be used for iin
extended period of time.
If the batteries leak, dispose of them immediately, taking care not
to touch the battery fluid. If the battery fluid comes into contact
with your eyes, mouth, or skin, rinse it off with water immediately,
and consult a doctor. Clean the baltery compartment thoroughly
before installing new batteries.
Remote control operation range
' If operation of this unit by the remote control creates any
malfunction in any other components, change the placemeiil of
the component.
' Do not spill any liquid on or drop the remote control. Do not
place it near a heater or in the bathroom w'here the temperature
and humidity become high.
' Make sure the remote control sensor is nol exposed to direct
sunlight or strong lights. If it is, it may not function correctly.
11