Autocue WinCue Pro News - Manual (Page 35)

WINCUEPRONEWS USER GUIDE
VERSION 1.30B515 35  QTV 1998
2nd from left, Known as the 'CUE STORY' button, it will move the prompt back to the
bottom row. very end of the previous story. This is useful to ensure that you are not pre-
empting the gallery as to which is the next story to prompt. Yet you are still
able to display enough of the next story for the presenter to start reading it.
CLEAR Dependant on whether you are using WinCue for Captioning.
DECODER
STOP Stop/Re-start the prompt scrolling.
Using the Foot Control to prompt
The scroll speed is controlled by increasing and decreasing the pressure applied to the foot
pedal (much like a car accelerator pedal). The red button on the foot control changes the
scroll direction in the same way as the Multibutton controllers FWD REV button.
If the Foot Control is attached to the back of a Multibutton Hand Control then the Foot Control
can be used in combination with the Multibutton Controls buttons.
3.1.9 Using WinCue to select the next story to prompt:
If it is necessary to jump the prompt to a story that is not the next or previous story in the
runorder then you can use any of the following three methods.
1: Hold down the left 'Alt' key and double left-click on the story you want to start
prompting.
2: Right-click on the story you want to start prompting, then select 'Prompt From Here'
from the drop-down menu that appears.
3: Left-click on the story you want to start prompting, this will select the story (shown by
the black bar), then hold down the left 'Alt' key and press the 'Return' or 'Enter' key.
After using any one of these methods, the prompt and the WinCue prompt (yellow) bar will
move/jump to the chosen story.