Autocue WinCue Pro News - Manual (Page 115)

WINCUEPRONEWS USER GUIDE
VERSION 1.30B515 115  QTV 1998
Centre Stop Mode is used if the operator does not wish to use the FWD/REV button to
change the direction of the prompted text. To enable the Centre Stop Mode, the check box
should be checked ( ). Next the Stop Point and Stop Zone should be set.
7.5.2 Configuring Scroll Control Buttons
The Buttons tab allows the user to configure each of the buttons individually. This means the
multi-button scroll control can be customised to suit a particular application.
These buttons are pre-configured for use. The standard settings are as shown overleaf.