Autocue WinCue Pro News - Manual (Page 13)

WINCUEPRONEWS USER GUIDE
VERSION 1.30B515 13  QTV 1998
1.6.3 Connecting a Composite Video Feed
The composite video port is the BNC port furthest the scroll control port on the I.M.T.
card. This port supplies the composite video feed to the prompter screen(s).
1.6.4 Connecting a Genlock Feed
The genlock port is the BNC port nearest from the scroll control port on the I.M.T. card.
This port accepts a genlock feed.
1.7 Installing the Hardware - Laptops
When the software has been installed and the PC turned off the laptop can be
connected to the I.M.T. box.
The I.M.T. scroll card inside the I.M.T. box has been configured prior to despatch for the
settings required in your country. Therefore it should not be necessary to open the
I.M.T. box or change jumpers or dip switch settings.
1.7.1 Connecting the I.M.T. Box to a Laptop
1. Insert the PCMCIA SCSI card into your laptop
2. Connect one end of the SCSI cable supplied with the SCSI card to the PCMCIA card
and the other to the SCSI port on the I.M.T. box
3. Connect a power cord to the appropriate input of the I.M.T. box (you have a choice of
IEC mains or 12V DC)
1.7.2 Connecting a Scroll Control
Laptops normally use the I.M.T. scroll control. The I.M.T. scroll control port is the 9 pin
analogue port on top of the I.M.T. box. WinCueProNews expects a scroll control to be
connected to this port.
The I.M.T. scroll control will not work if it is attached to any other port on your PC.
See Also
Refer to the laptop-wiring diagram in Appendix C