I.R.I.S. 808 Digital Video Recorder - Manual (Page 95)

 Focus Camera – the camera corresponding to the speed change alarm.
 Duration – response duration to define at most how long (in seconds) the Alarm
Out relay and the Buzzer will keep being triggered after the speed change alarm is
triggered. However, the Alarm Out relay and the Buzzer will be reset
immediately once the speed change alarm returns to normal, i.e. speed change
under the threshold. Press +/- buttons to adjust the value (3 seconds - 60 minutes,
discrete, ‘-‘ for ‘Forever’).
 Goto Preset – to define the preset position to go to for the Focus Camera if the
speed change alarm is triggered and the Focus Camera is a PTZ camera. For
more details about preset locations, please refer to
Chapter 7 PTZ Control .
 Pre-record – to define how long before the speed change alarm is triggered the
Focus Camera shall be intensively recorded at Pre-record IPS. Press +/- buttons
to adjust the value (0-10 seconds, discrete). Please note that the actual pre-record
time may be shorter than the value set if the total size of the pre-record pictures
exceeds the pre-record buffer size of the system.
 Post-record – to define how long after the speed change alarm is triggered the
Focus Camera shall be intensively recorded at Event Record IPS. Press +/-
buttons to adjust the value (0 second - 60 minutes, discrete).
 Alarm Out – to define which Alarm Output will be triggered when the speed
change alarm is triggered. Press +/- buttons to select none (N/A) or one of the
Alarm Outputs (1-2).
 Buzzer – to activate the internal Buzzer or not when the speed change alarm is
triggered. Press ENTER or +/- to check/uncheck this item. The default setting is
“ˇ” - checked.
 Log – to log to event logs or not. Press ENTER or +/- to check/uncheck this
item. The default setting is “ˇ” - checked.
 Screen Message – to display the event message on the screen or not. Press
ENTER or +/- to check/uncheck this item. The default setting is “ˇ” - checked.
 E-mail – to send the event e-mail to remote station or not. The e-mail will be sent
to the predefined receivers when the event is triggered. Press ENTER or +/- to
check/uncheck this item. The default setting is “–” - unchecked.
 FTP – to send the recorded event video/audio files to FTP server or not. Press
95