Acme PP-32 - Manual (Page 100)

100
PP-32
KOOLMASTER PP-32
REV.01
Clock output settings 45–47
Factory settings 90
Fan stages settings 38
Heater settings 41
Humidity compensation 82–85
Inlet settings 21–22
Minimum ventilation settings 19–20
Password settings 61–62
Relay assignment 70–76
Sensor assignement settings 66–69
Time & date settings 70
Tunnel ventilation settings 31–37
Vent doors settings 23–30
Setup
Installation setup 63–65
Step by step installation 59–60
Sidewall ventilation see Vent doors or Inlets
Static pressure
Activating the static pressure sensor 64
Calibrating the static pressure sensor 87
Static pressure alarms 56–58
Assigning relays for lo SP alarm 76
Static pressure Hi and Lo alarm limits 33, 56
Static pressure for tunnel curtains
Activating tunnel curtains in SP mode 63
Static pressure set points 36
Static pressure for vent doors
Groups of static pressure set
points 24, 25, 28–30
Static pressure set points 26
Static pressure units 14
Viewing the current static pressure level 15
Summer see Seasons
T
Table of contents 3
Tables see Templates
Technical specifications 89
Temperature
Activating temperature sensors 65
Average room temperature 15
Adjusting the temperature in test mode 88
Assigning sensors to the Room T° 66
Critical temperature 53, 55
History
History of the average temperature 48
History of the outside temperature 49
Outside temperature
Activating outside temperature sensor 65
Calibrating the outside temperature sensor 86
Outside influence on temperature alarms 53
Pressure set points influenced by out. T° 25
Viewing current outside temperature 15
Temperature alarms see Alarms
Temperature curve 78
Temperature set point see Set points
Temperature units 14
Temperature units 14
Templates 93–96
Installation setup template 95
Relay assignment template 96
Sensor assignment template 94
Test mode 88
Time
Reset time 63
Setting time and date 70
Setting time units 14
Timer
Minimum ventilation timer 20
Timer relays on fan stages 39, 72
Tunnel curtain timer 36
Vent doors timer 26
Tunnel curtain see Tunnel ventilation
Tunnel ventilation 31–37
Activating the tunnel curtain 63
Assigning relays to the tunnel curtain 74
Curtain controlled by static pressure 31
Pre-opening delay 32, 63
Selecting tunnel mode : SP/Timer 63
Tunnel and sidewall transition 33
Tunnel curtain controlled by static pressure 32
Tunnel curtain in timer mode 31
U
Units
Unit selection 14
User password 61
User setup see Installation setup
V
Vent doors
Adjusting vent door settings 23–30
Assigning relays to vent doors 73
Pre-opening delay 19, 20, 63
Tunnel and sidewall transition 33
Vent doors' operation 21
Ventilation
Endwall ventilation see Tunnel ventilation
Sidewall ventilation see Inlets or Vent doors
W
Water
Calibrating the water counter 77
History of the water consumption 50
Water unit selection 14
Weather see Temperature
Winter see Seasons
Wiring 11