IEI Integration TDM_Series v2.01 - Manual (Page 5)

TDM Series LCD Monitor
Page V
ƒ Explosions may occur with installations in environments where flammable
gases are present.
ƒ Fault-tolerant and failsafe designs should be implemented with the use of the
series models on transportation vehicles, ships, safety/security devices, or
medical devices not related to life-support functionalities. Users/integrators
should take the responsibility for implementations with adequate levels of
reliability and safety.
FURTHER PRECAUTIONS
ƒ Do not drop the monitor against a hard surface. Doing so will damage the
display.
ƒ Do not strike or exert excessive force onto the touch screen.
ƒ Touching the touch screen using a sharp object will damage the LCD panel.
ƒ Avoid environments exposed to direct sunlight, dust, or chemical vapors.
ƒ The ambient temperature of the installation site should be observed and
controlled to avoid overheating the monitor.
ƒ Condensation might form inside the monitor chassis if exposed to sudden
changes in temperature.
ƒ Carefully route the power cord so that people cannot step on it. Do not place
anything over the power cord.
ƒ If the equipment should be left unused for an extended period of time,
disconnect it from the power source to avoid damage by transient
over-voltage.
ƒ If any of the following situations arise, have the equipment checked by
qualified service personnel:
o The power cord or plug is damaged.
o Liquid has penetrated into the equipment.
o The equipment has been exposed to moisture.
o The equipment does not work properly, or cannot be made to work
according to the user manual.
o The equipment has been dropped and damaged.
o The equipment shows obvious signs of damage.