IEI Integration TDM_Series v2.01 - Manual (Page 43)

TDM Series Monitor
Page 29
4.3.2 Voltage Select Jumper Settings
If the monitor comes with both 12V and 9 ~ 36V DC power connectors, the voltage select
jumper on the integrated AD board must be configured for the DC connector that is used
to power the monitor. Refer to Section 4.3.2 for the appropriate jumper settings of the AD
board.
NOTE:
The default voltage select jumper is configured for a 12V power source.
Do not change the jumper setting unless a 9~36V DC power connector
is to be used as the monitor’s power source.
To properly set the voltage select jumper, the following steps must be completed:
Step 1: Use a screwdriver to remove all the screws holding the rear panel to the monitor.
Step 2: Remove the rear panel.
Step 3: Locate the voltage select jumper. (See Section 4.3)
Step 4: Use the jumper(s) to set the correct voltage input. (See Section 4.3.2)
Step 5: Replace the rear panel.
Step 6: Replace all removed screws. Step 0: