beautypg.com

2 unpacking, 1 packaging, 2 unpacking procedure – IEI Integration TDM_Series v2.01 User Manual

Page 41: Npacking

background image

TDM Series Monitor

Page 27

4.2 Unpacking

4.2.1 Packaging

When shipped, the TDM series industrial monitor is wrapped in a plastic bag. Two

polystyrene ends are placed on either side of the monitor. The monitor is then placed into

a first (internal) cardboard box. This box is then sealed and placed into a second (external)

cardboard box. The second box is also sealed. A bag containing accessory items is

placed underneath the monitor, at the bottom of the internal (first) box.

4.2.2 Unpacking Procedure

To unpack the TDM series industrial monitor, follow the steps below:

WARNING:

The front side LCD screen has a protective plastic cover stuck to the

screen. Only remove the plastic cover after the TDM series industrial

monitor has been properly installed. This ensures the screen is

protected during the installation process.

Step 1:

Use box cutters, a knife or a sharp pair of scissors to open the seal on the top

side of the external (second) box.

Step 2:

Open the external (second) box.

Step 3:

Use box cutters, a knife or a sharp pair of scissors the seal on the top side of the

internal (first) box.

Step 4:

Lift the monitor out of the boxes.

Step 5:

Remove both polystyrene ends, one from each side.

Step 6:

Pull the plastic cover off the TDM series industrial monitor.

Step 7:

Make sure all the components listed in the packing list are present.

Step 0: