5 set rf320 mode, Table 3-9: get mifare parameter raw data format, Table 3-10: get mifare parameter response format – IEI Integration ACT-457A User Manual
Page 47: A ( figure 3-5 ), Figure 3-5 ), Ed in table 3-7
ACT-457A Panel PC
Page 39
Field
Command
End
Data RM
CR
(0x0d)
Table 3-9: Get Mifare Parameter Raw Data Format
Status (2 digits)
Block Data
END (2 digits)
OK
Access mode (1 digit) +
Block (2 digits) + Mode (1 digit)
CR,LF (0x0d,0x0a)
ER
Error Code (3 digits)
CR,LF (0x0d,0x0a)
Table 3-10: Get Mifare Parameter Response Format
3.5.5 Set RF320 Mode
The Set RF320 Mode command is to set the type of RFID card for the RFID reader to
detect. To set the type of RFID card, please follow the steps below.
Step 1:
Select Set RF320 Mode in the command area (Figure 3-7).
Step 2:
Select a RF320 mode.
1-EM12K: detect EM cards only.
2-Mifare: detect Mifare cards only.
3-EM and Mifare: detect both EM and Mifare cards.
Step 3:
Click the Execute button to execute the command through the selected serial
port (Figure 3-7). The raw data of this command shows in the Raw Data area in
the format listed in Table 3-11 and Table 3-12.
Step 0: