IEI Integration ACT-457A User Manual

Page 32

ACT-457A Panel PC

Page 24

NOTE:

When purchasing the arm please ensure it has a 75 mm x 75 mm

mounting hole pattern. Only this mounting size will support the

ACT-457A.

Step 2:

Once the mounting arm has been firmly attached to the surface, lift the flat panel

PC onto the interface pad of the mounting arm.

Step 3:

Align the retention screw holes on the mounting arm interface with those in the

flat panel PC. The ACT-457A arm mount retention screw holes are shown in

Figure 2-13: ACT-457A Arm Mounting Retention Screw Holes

Step 4:

Secure the flat panel PC to the interface pad by inserting four retention screws

through the bottom of the mounting arm interface pad and into the flat panel