3 installation and configuration steps, 4 rear panel removal, Nstallation and – IEI Integration ACT-457A User Manual

Page 23: Onfiguration, Teps, Anel, Emoval, Figure 2-1: rear panel retention screws

ACT-457A Panel PC

Page 15

2.3 Installation and Configuration Steps

The following installation steps must be followed.

Step 1:

Unpack the ACT-457A

Step 2:

Install SD card (if not pre-installed)

Step 3:

Configure the system

Step 4:

Connect peripheral devices to the bottom panel of the ACT-457A.

Step 5:

Mount the ACT-457A

2.4 Rear Panel Removal

To access the jumpers and connectors, the rear panel must be removed.

Step 1:

Place the ACT-457A monitor side down on a flat surface.

Step 2:

Remove the rear panel screws and lift the back cover off.

Figure 2-1: Rear Panel Retention Screws