IEI Integration ACT-457A - Manual (Page 43)

ACT-457A Panel PC
Page 35
Field Command Block KEY KEY Data Time Out End
Data RB 00~63 A/B 000000000000
︴(Hex)
FFFFFFFFFFFF
00~99
(Second)
CR
(0x0d)
Table 3-3: Read Block Raw Data Format
Status (2 digits) Block Data (32 digits) END (2 digits)
OK 32 bits (Hex) CR,LF (0x0d,0x0a)
ER Error Code (3 digits) CR,LF (0x0d,0x0a)
Table 3-4: Read Block Response Format
3.5.2 Write Block
To write the block data into a Mifare card, please follow the steps below.
Step 1: Select Write Block in the command area (Figure 3-4).
Step 2: Configure the data, including block, key, key data, time out and data
(Figure 3-4).
Step 3: Click the Execute button to execute the command through the selected serial
port (Figure 3-4). The raw data of this command shows in the Raw Data area in
the format listed in Table 3-5 and Table 3-6. Step 0: