IDEC DATAVS2 Series - Manual (Page 12)

SVS2 Series Instruction Manual
7
If you use a direct connection:
• From menu START select Control Panel Network Connections LAN Conncetion;
• Press the right mouse button and select Properties;
• Select Internet Protocol (TCP/IP) then click the Properties button (as shown below);
• Select Use the following IP Address option;
• Enter the following:
IP ADDRESS: 172.27.101.1;
SUBNET MASK: 255.255.0.0;
Note:
no entries for Default Gateway or Use the following DNS Server Address are necessari.
• Click OK to close the dialog TCP/IP properties; then click OK at the LAN Properties dialog.
If you are connected to the sensor through a routing device you should first verify if the network hosts
a DHCP server.
• If the network hosts a DHCP Server
o
From menu START select Control Panel Network Connections LAN Connections;
o
Press the right mouse button and select Properties;
o
Select Internet Protocol (TCP/IP) then click Properties button again;
o
Finally select Obtain an IP Address automatically.
• If the network doesn’t host a DHCP Server:
o
Please contact your local IT manager for assigning an IP Address toyour PC;
o
Follow the instructions for direct connection configuration (pag. 8).