Quantum 10K II - Manual (Page 52)

Installation
Quantum Atlas 10K II Ultra 160/m SCSI Hard Disk Drives 3 − 25
3.6.7 Installation in a 5.25-inch Bay
CAUTION
Screws used to mount the drive must not exceed 0.25-inch
(6.25 millimeters) in length, or the drive may be damaged.
Figure 3-14 shows the brackets representative of those used to mount the drive in a
5.25-inch bay. A bracket kit including four screws is available from Quantum
Corporation. The part number of the kit is 70-30695-01.
SIDE
BRACKET
SIDE
BRACKET
Figure 3-14 Brackets for 5.25-inch Bay
Attach the brackets to the drive using four #6-32 screws (see Figure 3-11).
Mount the drive in the bay by performing the following steps:
1. Position the completed unit (drive and brackets) in the bay.
2. Secure the unit with screws at the selected mounting hole locations.
3.6.8 Backplane Installation (SCA Drive)
CAUTION
Screws used to mount the drive must not exceed 0.25-inch
(6.25 millimeters) in length, or the drive may be damaged.
Because of the variety of mounting possibilities, these instructions are general in
nature. They should be used only as a guide for mounting the drive in your
particular system.
Mount the drive as follows:
1. Position the drive in the bay.
2. Align the RAID connector on the drive to the backplane connector in the
system.