Quantum 10K II - Manual (Page 51)

Installation
3 − 24 Quantum Atlas 10K II Ultra 160/m SCSI Hard Disk Drives
Figure 3–13 Widthwise Airflow Cooling
3.6.6 Installation in a 3.5-inch Bay
CAUTION
Screw-length must not exceed 0.25-inch (6.25 millimeters) or the drive may
be damaged.
The drive base contains threaded holes on its sides and bottom to mount the drive
(see Figure 3-9 or Figure 3-10). The holes accept #6-32 screws.
NOTE
Mounting brackets may used when installing the drive in a 5.25-inch form
factor bay. Brackets supplied by Quantum Corporation to mount the drive are
recommended, otherwise, the drive’s isolation characteristics may be
affected. A Bracket kit (part no. 70-30695-01) is available from the Quantum
Corp.
To mount the drive:
1. Position the completed drive in the drive bay and choose the drive base
mounting holes that match the bay mounting locations.
2. Insert and secure the screws at the selected locations.