Quantum 10K II - Manual (Page 127)

SCSI Description
5–60 Quantum Atlas 10K II Ultra160/m SCSI Hard Disk Drives
MODE SELECT (6) Command (15h) (continued)
5.14.1 Initiator-Changeable Mode Pages
Table 5-26 lists the mode pages that are supported by the drive. An initiator can
change these pages by supplying them, with the desired changes included, in the
MODE SELECT command’s data-out buffer transfer.
The initiator should first use a MODE SENSE command to read the appropriate
pages and leave non-changeable values as read when the initiator subsequently
writes the changeable pages with the MODE SELECT command. If a non-
changeable field contains an invalid value, the drive returns a CHECK
CONDITION status.
Table 5–26 Initiator-Changeable Mode Pages
Page Code Page Name Function Size In Bytes
00h Unit Attention Control Page Unit Attention reporting 4
(enables or disables)
01h Read-Write Error Recovery Medium Access Error recovery 12
Page and reporting procedures for
READ and WRITE commands
02h Disconnect-Reconnect Page Bus behavior during data transfers 16
07h
1
Verify Error Recovery Page Medium Access Error recovery 12
and reporting procedures for the
VERIFY command
08h
1
Caching Page Cache policy 20
0Ah
1
Control Mode Page Command processing policy 12
0Ch Notch and Partition Page 2 Drive geometry reporting 24
10h XOR Control Page Controls XOR operating parameters 24
1Ah Power Condition Page Enable and set time intervals for Idle 12
and Standby modes
1Ch
1
Information Exceptions Defines methods to control reporting 12
Control Page and operations of specific informational
exception conditions.
39h Quantum-Unique Page 22
NOTES:
1. This page is not supported by the SCSI-1/CCS Operating Mode.
2. The Notch and Partition page is changeable but NOT savable.