Sanyo DSR-5716P - Manual (Page 121)

120
English
GENERAL SET 3
INTRODUCTION
SE
TTINGS
NE
T
W
O
R
K
CO
NT
RO
L
NETW
ORK
O
P
E
RATION
NE
T
W
ORK
S
E
TTINGS
OTHE
R
OPE
RATION
Settings are required when RS-485 terminal (A and B) is
connected with a system controller or other devices.
1
Press the [MENU] button.
The MENU indicator lights up and the
2
Turn the jog dial to select “3.GENERAL
SET” and then turn the shuttle dial
clockwise.
The screen is displayed.
3
Turn the jog dial to select “4.RS-485
SET” and then turn the shuttle dial
clockwise.
The screen is displayed.
4
Turn the shuttle dial clockwise.
“19200” flashes for “DATA SPEED”.
5
Turn the jog dial to select the “DATA
SPEED” setting and then turn the
shuttle dial clockwise.
The cursor moves to “STATUS INFO”.
[Settings] (‹ indicates default setting)
6
Turn the shuttle dial clockwise.
“OFF” flashes for “STATUS INFO”.
7
Turn the jog dial to select “STATUS
INFO” and then turn the shuttle dial
clockwise.
The cursor moves to “ALARM INFO”.
[Settings] (‹ indicates default setting)
Setting RS-485
MENU
DATA SPEED : 19200
STATUS INFO : OFF
ALARM INFO : OFF
ADDRESS : 001
DATA SPEED : 19200
STATUS INFO : OFF
ALARM INFO : OFF
ADDRESS : 001
Setting Description
2400, 4800, 9600, ‹19200 Sets the data speed.
Setting Description
ON Status information is transmitted.
‹ OFF Status information is not transmitted.
DATA SPEED : 19200
STATUS INFO : OFF
ALARM INFO : OFF
ADDRESS : 001
DATA SPEED : 19200
STATUS INFO : OFF
ALARM INFO : OFF
ADDRESS : 001
DATA SPEED : 19200
STATUS INFO : OFF
ALARM INFO : OFF
ADDRESS : 001