Integra CROMA24 - Manual (Page 97)

Assembly\Disassembly 97
ASSEMBL
Y/
DISASSEMBL
Y
Croma24 Service Manual
9. Push the Carrier Belt through the Frame Tensioner enough
to remove the Idler Pulley Assembly from the Frame
Tensioner, and then set aside the Idler Pulley Assembly and
the Frame Tensioner. (See Figure 5-6 for part identification,
if necessary.)
10. Slide the Carrier Assembly and Drive Belt off the left side of
the Slide Shaft.
Figure 5-5. Carrier Belt Clamp.
11. Once the Carrier Assembly is removed from the Slide Shaft,
turn it over so that you can see the Belt Clamp. See
Figure 5-5.
12. To disengage the Carrier Belt from the Belt Clamp, push the
Carrier Belt away from the left post of the Belt Clamp and
gently lift up until the bottom edge of the Carrier Belt clears
the top of the left post.
13. Push the Carrier Belt away from the right post of the Belt
Clamp and gently lift up to finish removing the Carrier Belt
from the Belt Clamp.