Integra CROMA24 - Manual (Page 102)

102 Assembly\Disassembly
Croma24 Service Manual
Failure to use an approved anti-static bag for storage
or shipment may cause damage to the Carrier PCB
and affect the Warranty.
6. Place the Carrier PCB in an ESD bag (anti-static bag) in
preparation for shipment to ENCAD for replacement or repair,
or if it is to be stored at your facility for repair.
Install the Carrier PCB
1. Put the tab on the left end of the Carrier PCB into the slot in
the left side of the Carrier Assembly. See Figure 5-7.
2. Ensure that no flex cables are underneath the Carrier PCB.
3. Push down the right end of the Carrier PCB until the latch
snaps into place.
4. Reattach all flex cables on the Carrier PCB. Ensure that the
ferrite remains on the black cartridge flex cable.
5. Perform the Carrier Assembly, Carrier Belt, and the Frame
Tensioner Reinstallation procedures to reinstall the Carrier
Assembly.
Remove the Paper Sensor or the Encoder Sensor
1. Perform the Carrier Assembly, Carrier Belt, and the Frame
Tensioner Removal procedures to remove the Carrier Assembly
from the Slide Shaft.