Integra CROMA24 - Manual (Page 120)

120 Assembly\Disassembly
Croma24 Service Manual
Install the Power Supply and AC Entry Module
1. Insert the AC Entry Module by snapping it into the Power
Supply base.
2. Install Power Supply board into the Power Supply base using
four mounting screws and washers. Attach the ground wire
from the AC Entry Module to the lower Power Supply cover
mounting screw.
3. Connect the AC Entry Module plug into TB1 on the Power
Supply board.
4. Attach the Power Supply cable to the TB2 connector on the
Power Supply board.
5. Place the Power Supply cover over the assembly and slide into
place over the loosened screws on the Power Supply base.
Ensure that the grounding strap is still attached to the screw
on the Power Supply base.
6. Insert the Power Supply Assembly into the printers Base.
Orient the assembly so that the extensions on the back of the
Power Supply base slip into the square holes in the Base of the
printer and that the AC Entry Module extends through the
back of the printer.
7. Apply pressure downward on the Power Supply Assembly until
it snaps firmly into place.
8. Connect the ground lug to the grounding stud on the Base. See
Figure 5-17.
9. Position the Power Supply cable into the cable supports inside
the front part of the Base until it reaches the MPCB.
10. Connect the Power Supply cable to the J5 connector on the
MPCB.
11. Carefully secure the Platen onto the printer Base. Ensure that
the ground straps for the Slide Shaft and C-Bracket are coming
through the holes in the Platen.