Integra CROMA24 - Manual (Page 106)

106 Assembly\Disassembly
Croma24 Service Manual
4. Remove the Trailing Cable from the triangular portion of the
Strain Relief.
5. Lift up on the short end of the tape and unfold the bend in the
Trailing Cable.
6. Remove the Strain Relief by pushing the Trailing Cable down
through the opening in the Strain Relief.
7. Disconnect the Trailing Cable connector at the J6 location on
the MPCB. Use the thumb and forefinger to pull forward on
the connector lock and remove the Trailing Cable from the
connector. See Figure 3-6 if necessary.
Figure 5-10. Trailing Cable Assembly Removal/Installation.