Wall or under-table mounting, Wall or under-table mounting -13 – HP 2520G-POE User Manual

Page 33

2-13

Installing the Switch

Installation Procedures

Wall or Under-Table Mounting

You can mount the switch on a wall with either the front or rear panel facing
up.

W A R N I N G

For safe operation, do not install the switch with side ventilation or
fan ducts facing up or down.

For the Switch 2520G-8-PoE, the network ports must be facing up. Do
not mount the switch with ports facing down.

C a u t i o n

The switch should be mounted only to a wall or wood surface that is at least
1/2-inch (12.7 mm) plywood or its equivalent.

Use a #1 Phillips (cross-head) screwdriver and attach the mounting
brackets to the switch with the included 8-mm M4 screws.

Attach the switch to the wall or wood surface with two 5/8-inch number
12 wood screws (not included).

Figure 2-7. Wall Mounting the Switch 2520G-24-PoE

Wall

5/8-inch

wood screws

RJ-45 Ports