HP ProLiant DL385 - Manual (Page 81)

Hardware options installation 81
6. Reposition the cable management arm into the operating position.
7. Connect the power cord to the power source.
8. Be sure that the power supply LED is green.
9. Be sure that the front panel external health LED is green ("Front panel LEDs
and buttons" on page 11 ).
Expansion board options
NOTE: This procedure shows images of the SCSI model server, but it
also applies to the SAS model server.
The server supports PCI and PCI-X expansion boards.
For instructions on installing a RILOE II board, refer to the HP Remote Insight
Lights-Out Edition II User Guide on the Documentation CD.
IMPORTANT: The optional RILOE II board can be installed only in
slot 3. If you plan to install a RILOE II board in the future, leave slot 3
unpopulated.
1. Power down the server ("Powering down the server" on page 35 ).
2. Extend or remove the server from the rack ("Extending the server from the
rack" on page 37 ).
3. Remove the access panel.