HP 2610-PWR - Manual (Page 81)

GVRP
Introduction
Figure 3-8. Example of Preventing Specific Ports from Joining Dynamic VLANs
Displaying the Static and Dynamic VLANs Active on the Switch. The
show vlans command lists all VLANs present in the switch.
Syntax: show vlans
For example, in the following illustration, switch “B” has one static VLAN (the
default VLAN), with GVRP enabled and port 1 configured to
Learn for
Unknown VLANs. Switch “A” has GVRP enabled and has three static VLANs:
the default VLAN, VLAN-222, and VLAN-333. In this scenario, switch B will
dynamically join VLAN-222 and VLAN-333:
Switch “B” Switch “A”
Port 1: Set to
“Learn” Mode
GVRP enabled.
3 Static VLANs:
GVRP enabled.
1 Static VLANs:
– DEFAULT_VLAN – DEFAULT_VLAN
– VLAN-222
– VLAN-333
Figure 3-9. Example of Switches Operating with GVRP Enabled
The show vlans command lists the dynamic (and static) VLANs in switch “B”
after it has learned and joined VLAN-222 and VLAN-333.
3-15