HP 2610-PWR - Manual (Page 54)

Static Virtual LANs (VLANs)
Port-Based Virtual LANs (Static VLANs)
For example, suppose a dynamic VLAN with a VID of 125 exists on the switch.
The following command converts the VLAN to a static VLAN.
ProCurve(config)# static-vlan 125
Configuring Static VLAN Name and Per-Port Settings
The vlan <vlan-id> command, used with the options listed below, changes the
name of an existing static VLAN and changes the per-port VLAN membership
settings.
N o t e You can use these options from the configuration level by beginning the
command with
vlan <vlan-id>, or from the context level of the specific VLAN.
Syntax: name <vlan-name>
Changes the name of the existing static VLAN. (Avoid
spaces and the following characters in the
< vlan-name>
entry: 2, #, $, ^, &, *, (, and ).)
[no] tagged <port-list>
Configures the indicated port(s) as Tagged for the specified
VLAN. The “ no” version sets the port(s) to either No or (if
GVRP is enabled) to Auto.
[no] untagged <port-list>
Configures the indicated port(s) as Untagged for the
specified VLAN. The “ no” version sets the port(s) to either
No or (if GVRP is enabled) to Auto.
[no] forbid <port-list>
Configures the indicated port(s) as “forbidden” to
participate in the designated VLAN. The
“ no” version sets
the port(s) to either No or (if GVRP is enabled) to Auto.
auto <port-list>
Available if GVRP is enabled on the switch. Returns the
per-port settings for the specified VLAN to
Auto operation.
Note that Auto is the default per-port setting for a static
VLAN if GVRP is running on the switch. (For information
on dynamic VLAN and GVRP operation, see
chapter 3, “GVRP”.)
For example, if you have a VLAN named VLAN100 with a VID of 100, and all
ports are set to
No for this VLAN. To change the VLAN name to “Blue_Team”
and set ports 1-5 to Tagged, you could do so with these commands:
2-28