Cli: viewing and configuring gvrp, Cli: viewing and configuring gvrp -13 – HP 2610-PWR User Manual
Page 79
GVRP
Introduction
3. Use the arrow keys to select the port you want, and the Space bar to select
Unknown VLAN option for any ports you want to change.
4. When you finish making configuration changes, press
[Enter]
, then
[S]
(for
Save) to save your changes to the Startup-Config file.
CLI: Viewing and Configuring GVRP
GVRP Commands Used in This Section
show gvrp
below
gvrp
unknown-vlans
Displaying the Switch’s Current GVRP Configuration.
This command
shows whether GVRP is disabled, along with the current settings for the
maximum number of VLANs and the current Primary VLAN. (For more on the
last two parameters, see “Port-Based Virtual LANs (Static VLANs)” on page
2-4.)
Syntax:
show gvrp
Shows the current settings.
Figure 3-6. Example of “Show GVRP” Listing with GVRP Disabled
3-13