HP 2610-PWR - Manual (Page 323)

ProCurve Stack Management
Configuring Stack Management
Figure 8-8. The Default Stack Configuration Screen
3. Move the cursor to the Stack State field by pressing [E] (for Edit).
4. Do one of the following:
• To disable stacking on the Candidate, use the Space bar to select
the Disabled option, then go to step 5.
Note: Using the menu interface to disable stacking on a Candidate
removes the Candidate from all stacking menus.
• To insert the Candidate into a specific Commander’s stack:
i. Use the space bar to select Member.
ii. Press [Tab] once to display the Commander MAC Address param­
eter, then enter the MAC address of the desired Commander.
• To change Auto Join or Transmission Interval, use [Tab] to select the
desired parameter, and:
– To change Auto Join, use the Space bar.
– To change Transmission Interval, type in the new value in the
range of 1 to 300 seconds.
Note: All switches in the stack must be set to the same transmis­
sion interval to help ensure proper stacking operation. ProCurve
recommends that you leave this parameter set to the default 60
seconds.
Then go to step 5.
8-17