Honeywell HRSD4 - Manual (Page 70)

Configuration
70
1. Highlight Alarm-In Event Action (Alarm Out) in the Event Action menu and press
. The Alarm In Event Action (Alarm Out) setup screen appears.
Figure 3-37 Alarm In Event Action (Alarm Out) Setup Screen
2. Highlight the Sched field and press . A schedule screen appears. Set the
schedule as described earlier see Scheduling an Alarm Output on page 59 ).
3. Highlight the Alarm Out field and select either Beep or the alarm output terminal
that you want to associate with the sensor.
4. Highlight the Dwell Time field and set the length of time you want the output
activated. You can select from 1 to 300 seconds.
5. Save your changes by highlighting OK and pressing . Select Cancel to exit
the screen without saving the changes.
Alarm In Event Action (Notify) Setup Screen
The DVR can be set to notify the remote site when certain events are activated.
1. Highlight Alarm-In Event Action (Notify) in the Event Action menu and press
. The Alarm In Event Action (Notify) setup screen appears.
Figure 3-38 Alarm In Event Action (Notify) Setup Screen