HP M305/M307 - Manual (Page 88)

88 HP Photosmart M305/M307 User’s Manual
Resetting the Camera
If your camera does not respond when you press any buttons,
try resetting the camera as follows:
1 Turn off the camera.
2 If you have an optional memory card installed, remove it.
(Although removing an optional memory card is not
necessary for performing the reset, it eliminates the memory
card as a possible cause of the problem.)
3 Reset the camera by removing power from it as follows:
• If you are powering the camera with only batteries, open
the Battery/Memory card door and remove both
batteries for approximately 5 seconds.
• If you are using only an optional HP AC power adapter
to power the camera, disconnect it from the camera for at
least 5 seconds.
• If you are using both batteries and the HP AC power
adapter, remove both for at least 5 seconds.
4 Reinsert the optional memory card (if you have one). Then
reinsert the batteries and close the Battery/Memory card
door, and/or reconnect the HP AC power adapter to the
camera. You may now use the camera again.