Hunter Fan 44668 User Manual

Page 7

REMOTE SENSORS (does not apply to thermostat

model 44660)

Your thermostat can support 3 remote sensors that

will measure the temperature from three different lo-

cations - two indoor and one outdoor. To configure your

thermostat to work with the remote sensors, follow the

instructions for Sensor Channel selection on page 13 of

this manual. To configure the remote sensors, consult

the Remote Sensor Instruction Manual.

NOTE (does not apply to thermostat model 44660):

This device complies with Part 15 of the FCC Rules. Op-

eration is subject to the following two conditions: (1) this

device may not cause harmful interference, and (2) this

device must accept any interference received, including

interference that may cause undesired operation.
This equipment has been tested and found to comply with

the limits for a Class B digital device, pursuant to Part 15

of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a

residential installation. This equipment generates, uses

and can radiate radio frequency energy and, if not installed

and used in accordance with the instructions, may cause

harmful interference to radio communications. However,

there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harm-

ful interference to radio or television reception, which can

be determined by turning the equipment off and on, the

user is encouraged to try to correct the interference by

one or more of the following measures:
• Increase the separation between the equipment and

receiver.

• Connect the equipment into an outlet on a circuit dif-

ferent from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV techni-

cian for help.

This manual is related to the following products: