Honeywell XENON 1902 - Manual (Page 85)

3 - 23
To rename scanners with sequential, numeric names, scan the bar codes
below.
Scan the Reset code after each name change and wait for the scanner
to relink to the base or Access Point before scanning a bar code to rename the
next scanner.
You may also scan the Scanner Name bar code below and scan a number for
the scanner name. For example, if you wanted to name the linked scanner
“312,” you would scan the bar code below, scan the 3, 1, and 2 bar codes on the
Programming Chart inside the back cover of this manual, then scan Save. Scan
the Reset bar code and wait for the scanner to relink to the base.
0001
0002
0003
0005
0007
0004
Reset
0006
Scanner Name