Paging, Paging mode, Paging pitch – Honeywell XENON 1902 User Manual
Page 71: Error indicators, Beeper pitch - base error, Paging -9, Paging mode -9 paging pitch -9, Error indicators -9, Beeper pitch - base error -9, Pitch
3 - 9
Paging
Paging Mode
By default, the paging button on the base or Access Point pages the scan-
ners associated with that base or Access Point. If you want the paging but-
ton on your base or Access Point to be disabled, scan the Paging Mode
Off bar code, below. When Paging Mode is off, the base or Access Point
will no longer page scanners when the button is pressed. The red LED on
the base or blue LED on the Access Point will remain lit to indicate that
Paging Mode is off. (This light will go out when the button is pressed, then
back on when it’s released.)
Default = Paging Mode On.
Paging
Pitch
When you press the Page button on the base or Access Point, the scan-
ners associated with that base or Access Point will begin beeping (see
on page 3-4). You can set the pitch of the paging beep for
each scanner by scanning one of the following bar codes.
Default = Low.
Error Indicators
Beeper Pitch - Base Error
Note: This feature does not apply to the Access Point.
* Paging Mode On
Paging Mode Off
* Low (1000 Hz)
Medium (3250 Hz)
High (4200 Hz)