Honeywell XENON 1902 - Manual (Page 223)

8 - 19
Y - Vertical Bar Code Offset
The vertical bar code offset allows you to offset the vertical center of the
signature capture area. Negative numbers indicate that the signature cap-
ture is above the bar code, and positive numbers indicate that the area is
below the bar code. Measurements are in multiples of the minimum bar
width.
RF Default Imaging Device
The scanner supports imaging command processing (IMGSHP, IMGSNP, IMG-
BOX) so that EZConfig-Scanning (see page
10-3 ) and other applications are
able to perform imaging functions as if they were communicating directly with a
scanner. To accomplish this, the scanner uses a menu command called
RF_DID (RF Default Imaging Device). RF_DID is the name of the scanner
(BT_NAM) that is to receive imaging commands. The default for RF_DID is
“*”indicating that imaging commands are to be sent to all associated scanners.
Change this setting to RF_DID
scanner_name to ensure that they are sent to a
particular scanner. Refer to "Paging" on page 3-9 to generate a report contain-
ing the port, work group, scanner name, and address for each scanner. Refer to
"Scanner Name" on page 3-22 set a unique name for each scanner.
Example of Vertical Offset set to -7Y:
Example of Vertical Offset set to 65Y: