Honeywell XENON 1902 - Manual (Page 112)

4 - 16
Aimer Delay
The aimer delay allows a delay time for the operator to aim the scanner before
the picture is taken. Use these codes to set the time between when the trigger
is pulled and when the picture is taken. During the delay time, the aiming light
will appear, but the LEDs won’t turn on until the delay time is over.
Default =
Off.
User-Specified Aimer Delay
If you want to set your own length for the duration of the delay, scan the bar
code below, then set the time-out by scanning digits (0 - 4,000 ms) from the
Programming Chart inside the back cover of this manual, then scan Save.
Scanner Time-Out
Note: Scanner Time-Out applies only to corded scanners. It does not apply to
cordless systems.
Scanner Time-Out powers down the scanner after the unit has been idle for the
specified time. To prevent the scanner from powering down, set this time-out to
0. Scan Scanner Time-Out, then set the time-out by scanning digits (from 0 -
999,999 ms) from the inside back cover, then scanning Save.
Default = 1 ms.
400 milliseconds
* Off (no delay)
200 milliseconds
Delay Duration
Scanner Time-Out