beautypg.com

To add an output sequence, Other programming selections – Honeywell XENON 1902 User Manual

Page 118

background image

4 - 22

To Add an Output Sequence

1. Scan the

Enter Sequence symbol (see

Require Output

Sequence

, page 4-25).

2. Code I.D.

On the

Symbology Chart

on page A-1, find the symbology to which you

want to apply the output sequence format. Locate the Hex value for
that symbology and scan the 2 digit hex value from the Programming
Chart (inside back cover).

3. Length

Specify what length (up to 9999 characters) of data output will be
acceptable for this symbology. Scan the four digit data length from the
Programming Chart. (Note: 50 characters is entered as 0050. 9999 is
a universal number, indicating all lengths.) When calculating the length,
you must count any programmed prefixes, suffixes, or formatted
characters as part of the length (unless using 9999).

4. Character Match Sequences

On the

ASCII Conversion Chart (Code Page 1252)

, page A-4, find the

Hex value that represents the character(s) you want to match. Use the
Programming Chart to read the alphanumeric combination that
represents the ASCII characters. (99 is the Universal number,
indicating all characters.)

5. End Output Sequence Editor

Scan

F F to enter an Output Sequence for an additional symbology, or

Save to save your entries.

Other Programming Selections

Discard
This exits without saving any Output Sequence changes.

This manual is related to the following products: