Hotpoint RGB747GER - Manual (Page 30)

CARE AND CLEANING
(continued)
Oven Air Vents
Never block the vents (air openings) of the range. They provide air
inlet and outlet that are necessary for the range to operate properly with
correct combustion. Air openings
located at the rear the
the top and bottom the oven door, and the bottom the range, under
the storage drawer.
Oven Lamp Replacement
CAUTION: Before replacing your oven bulb,
disconnect electrical power to the range at the
main fuse or circuit breaker panel. Be sure to let
the lamp cover and bulb cool completely.
The oven lamp (bulb) is covered with a removable
glass cover that is held in place with a bail-shaped
wire. Remove oven door, if desired, to reach cover
easily.
To remove:
1. Hold hand under cover it doesn’t when
released. With fingers same hand, firmly push
back wire bail until it clears cover. Lift off cover.
DO NOT REMOVE ANY SCREWS TO
REMOVE COVER.
2. Do not touch hot bulb with wet cloth. Replace
bulb with 40-watt household appliance bulb.
To replace cover:
1. Place it
into groove
lamp receptacle. Pull wire
bail forward to center of cover until it snaps into
When in place, wire holds cover firmly. Be
certain wire bail is in depression in center cover.
2. Connect electrical power to the range.
Metal Parts Glass Surfaces
Do not use steel wool, abrasives,
ammonia or commercial oven
cleaners. To safely clean surfaces;
wash, rinse and then dry with a
- @’ .
soft cloth.
. . . . . . .
To clean the outside
finish, use a glass
cleaner. Rinse and polish
with a dry cloth. Do not
allow the water or
cleaner to run down
inside openings in the
glass cleaning.
.
30