Hotpoint RGB747GER - Manual (Page 11)

OVEN CONTROL, CLOCK AND TIMER
Clock To Set the Clock
automatic oven timing functions to
cannot be changed during a TIME
3. Press the CLOCK pad to start.
Timer To Set the Timer
The timer is a minute timer; it does
not control oven operations. The
maximum setting on the timer
hours and 55 minutes.
o
1. Press the
TIMER pad.
TIMER
2. Press INCREASE or
DECREASE pad to set the
amount of time on timer.
The timer will start automatically
within a few seconds of releasing
the pad.
The timer, as you are setting it,
will display seconds until 60
seconds is reached.
Then it will display minutes
and seconds until 60 minutes
is reached.
After 60 minutes, it will display
hours (“HR” now appears in
display) and minutes until the
maximum time of 9 hours and
55 minutes is reached.
I
To Reset Timer To Cancel Timer Power Outage?
Press TIMER pad and then press Press TIMER pad until the word After a power outage, when power
INCREASE or DECREASE pad “TIMER” quits flashing on the is restored, the display will flash
until the time you want shows on display (about 4 seconds). and time shown will no longer be
the display. correct-for example, after a
5-minute power interruption the
clock will be 5 minutes slow.
The display flashes until the clock
is reset. All other functions that
were in operation when the power
went out will have to be
programmed again.
End of Cycle Tones Display Messages
The end of cycle tone is a series of three beeps If “door” appears on the display, the door latch
followed by one beep every six seconds. If you would handle is not moved all the way to the right. Move the
like to remove the signal that beeps every six seconds, latch handle and cleaning will start. If “LOCK”
press and hold the CLEAR/OFF pad for 10 seconds. appears on the display, the oven door is in the locked
To return the signal that beeps every six seconds,
position. BAKE, BROIL and COOK TIME cannot be
press and hold the pad for seconds.
set if the door is in the locked position.
11 I