Hayter Mowers RT380H - Manual (Page 43)

10. Remove and inspect the spark plug; refer to Servicing
the Spark Plug. With the spark plug removed from
the engine, pour 2 tablespoons of engine oil into the
spark plug hole. Use the electric starter to crank
the engine and distribute the oil inside the cylinder.
Install the spark plug, but do not connect the wire to
the spark plug.
11. Disconnect the negative battery cable. Clean the
battery and battery terminals. Check the electrolyte
level and charge it fully; refer to Servicing the Battery.
Leave the negative battery cable disconnected from
the battery during storage.
Important: The battery must be fully charged
to prevent it from freezing and being damaged at
temperatures below 32°F (0°C). A fully charged
battery can be stored during the winter without
recharging.
12. Check and tighten all bolts, nuts, and screws. Repair
or replace any part that is worn or damaged.
13. Paint all scratched or bare metal surfaces with paint
available from an Authorized Service Dealer.
14. Store the tractor in a clean, dry garage or storage area.
Remove the ignition and reverse interlock keys from
the tractor and keep them in a memorable place.
Cover the tractor to protect it and keep it clean.
43