Hayter Mowers RT380H - Manual (Page 37)

Figure 50
1. Idler spring 3. Idler arm
2. Eye-bolt 4. Idler pulley
8. Remove the bolts and lock nuts and pull the two
cutter deck pivot mount brackets down from the
front axle (Figure 51).
Figure 51
1. Pivot mount bracket 3. Locknut
2. Bolt (5/16 x 2-1/2 inch)
9. Remove the hairpin cotter and washer from the end
of the long rod (Figure 52). Slide the rod out of the
cutter deck mount.
Figure 52
1. Hairpin cotter and washer 3. Leveling bracket
2. Long rod 4. Cutter Deck mount
10. Remove the hairpin cotter and washer at the cutter
deck leveling bracket (Figure 52). Slide the bracket
off of the mounting pin. Install the washer and
hairpin cotter for storage.
11. Rotate the leveling bracket up toward the frame, and
hook the long rod into one of the holes to store.
Secure the long rod with the washer and hairpin
cotter.
12. Repeat 9 through 11 on the opposite side of the
cutter deck.
13. Move the height-of-cut lever into the “D” notch.
Hook the lift assist spring onto the retaining bolt
for storage (Figure 49).
14. Remove the cutter deck belt from the electric clutch
pulley (Figure 53).
Figure 53
1. Cutter Deck belt 2. Electric clutch pulley
15. Remove the cutter deck belt from the lower engine
pulley (Figure 53).
16. Turn the front wheels fully to the left. Slide the
cutter deck out to the right to complete removal.
37