Hayter Mowers RT380H - Manual (Page 11)

1
Installing the Front Wheels
Parts needed for this procedure:
2 Front wheels
2 Shim washers (as required)
2 Flat washers
2 Cotter pins
2 Hub caps
Procedure
1. Install the shim washers onto the axle.
2. Install the wheel onto the axle with the valve stem
facing out.
3. Slide the flat washer onto the axle (Figure 3).
Figure 3
1. Flat washer 3. Hub cap
2. Cotter pin
4. Insert the cotter pin through the axle and bend the
ends of the pin apart (Figure 3).
Note: If the cotter pin does not fit, remove the
shim washer(s) as needed.
5. Push the hub cap (Figure 3) onto the end of the axle.
6. Repeat steps 1 through 5 on the opposite side of
the tractor.
7. Grease the wheel bearings until the grease comes out
of the bearing seal area.
2
Checking the Tyre Pressure
No Parts Required
Procedure
Ensure that the air pressure in the front and rear tyres
are 20 psi (138 kPa). Check the pressure at the valve
stem (Figure 4).
Figure 4
1. Valve stem
3
Installing the Steering Wheel
Parts needed for this procedure:
1 Steering wheel
1 Spirol pin
Procedure
1. Move the front wheels so that they face straight
ahead.
2. Slide the steering wheel over the steering shaft and
line up the hole in the steering wheel with the hole in
the shaft (Figure 5).
Note: From the seat you should be able to read the
brand logo on the steering wheel.
11